AUTHORIZATION
◀
▶
Description
Technical Data
FAQ
Manual
System
Air washer (2in1)
Air washers (2in1)
Accessories (included in the set)
Water reservoir
Water reservoir
Room area m²
80
60
Room size m³
200
150
Power
550 g/h
400 g/h
Power level
4
4
Colors
Silver, Black
White
Water tank volume, ltr
6.3
3.2
Weight, kg
8.2
5.1
Dimensions, mm
321 x 471 x 235
315 x 418 x 215
Gross, kg
9.7
6.152
Packaging, mm
398 x 533 x 310
378 x 464 x 272
Electricity consumption, W
7-30
3-23
Noise level
27-56 dB(A)
27-48 dB(A)
Why can I barely smell the fragrance from my Robert?
The intensity of the fragrance is influenced by various factors:- Type of fragrance (synthetic, natural, ingredients, etc.)- Room temperature and relative humidity (the more humid the air, the stronger the fragrance will be)- Room size (the smaller the room, the more intense the fragrance) In principle, you can increase the intensity of a fragrance by adding a little more fragrance oil. The strength of a fragrance will depend on the fragrance itself. Natural fragrances are often more discreet than synthetic ones and certain ingredients are more dominant than others. It should also be remembered that first and foremost, the device is an air washer and therefore the intensity of the fragrance will never be as strong as the fragrance from an aroma diffuser.
Why won’t my Robert switch on any more and why won’t the display light up?
Please check to make sure that the water tray and the disc pack have been inserted into the device properly. You need to push the water tray in quite firmly until you hear a “click”.
Why is the humidity indicator flashing on the display?
If the humidity indicator starts flashing, it means that the desired humidity has been reached and the device has switched itself off automatically. The current humidity is measured approximately every 30 minutes (the fan will run for 1-2 minutes). If the current humidity measured falls below the set value, the device will start to humidify again. Press the "Air Humidity” button to reset the desired humidity. You can now select the desired humidity in increments of 5 by repeatedly pressing the "Air Humidity” button (the display will flash while you are doing this). If no adjustments are made for approximately 10 seconds, the value selected will be saved. The display will switch to the current humidity measured. Once the desired humidity is reached, the device will stop again and the display will flash.
Why is my Robert making strange noises?
The disc pack may become loose during operation or after cleaning. As a result, the toothed wheel on the disc pack will no longer grip properly. You can rectify the problem quite easily by tightening up the disc pack. This is done by turning the disc at the front clockwise with the toothed wheel.
When should I use the anticalc cartridge?
The anticalc cartridge reduces the lime content in the water and thus the decalcification intervals. With a water hardness above 7° dH, we recommend the use of the anticalc cartridge. The cartridge will need to be replaced every one to three months depending on how hard your water is. It is essential to use an anticalc cartridge if your water hardness exceeds 21 dH°.
